Here is a list of popular faults which may appear on your dishwasher from time to time.

If you need further help you can e-mail us with your question

Not showing any power –

·     Check the fuse – Might blow the fuse if there is a leak or wires make bad contact

·     Mains suppressor failure

·     Multi pin connectors loose at the circuit board

·     Door catch or On/Off button fault or related components fault

Power on but nothing happens-

·     Drain pump fault

·     Circuit board or timer fault

·     Door catch or On/Off button faulty or related components fault

·     Inlet valve fault

·     Water level sensor fault

Water continuously draining at the start-

·     Flood sensor activated. Possibly a leak into the base.

·     Water level sensor fault

·     Drain pipe too low

Water Enters at the start then stops-

·     Motor fault

·     Motor capacitor failure

·     Heating Element or thermostat fault

Water Enters at the start then stops & starts many times-

·     Gunge in the pipes in the base  or water flow chamber

Water will not drain-

·     Drain pump fault

·     Possible blockage in the drain pipe

·     Possible obstruction to the drain pump impellor. Usually chicken bone or glass

Water will not enter at the start-

·     Gunge in the pipes in the base  or water flow chamber

·     Inlet valve fault

·     Water level sensor fault

Wash cycle runs but dishes not properly clean-

·     Gunge in the pipes in the base  or water flow chamber

·     Heating Element or thermostat fault

·     Spray arms blocked

·     Filter blocked